Continuing from my previous post with the theme of network flexibility that is present in the 7.0.130 VxRail release. This post will look at a new feature that will allow customers to customize their entire vDS configuration. Traditionally all VxRail system VLANs needed to remain on a single vDS. System VLANs are categorized as Management,… Continue reading VxRail Multi vDS – System Traffic Separation.
Tag: Dell
Adding Vplex to DellEMC Vision Intelligent Operations
Q: How do I add additional components to my DellEMC Vision Intelligent Operations instance? A: This guide can be used pretty much for adding any additional devices to Vision as the majority of the procedure is the same. The main changes will be in the detail of the device type. In this example, I have used… Continue reading Adding Vplex to DellEMC Vision Intelligent Operations
iDRAC Powershell Setup and Basic Audit
With the introduction of the Dell Hardware into the VxRack SDDC and Flex1000 ecosystems, I figured I better spend some time figuring out the iDRAC PowerShell cmdlets. Prerequisites: Powershell v3 minimum Installed iDRAC Module Locations: http://en.community.dell.com/techcenter/systems-management/w/wiki/7727.powershell-cmdlets-for-poweredge-servers Check where your current modules are installed by running this command Get-Module –ListAvailable Your Module Location will be listed as below.… Continue reading iDRAC Powershell Setup and Basic Audit
https://cliffcahill.com 